Any way to delay the first update check?

system · 2007-03-02T22:43:21.000Z

Is there a way to delay the first update so it doesn’t slow my PC down to a crawl right after it boots up? Ideally, it would like the first update to occur maybe 5 or 10 minutes after booting.

DavidR · 2007-03-02T23:17:39.000Z

Yes.
:
:
:
:
OK then, but I doubt it needs to be 5 to 10 minutes.
It also depends on your connection dial-up or broadband ?

You need to edit the [InetWD] section of the C:\Program Files\Alwil Software\Avast4\Data\avast4.ini file and add the following line (depending on your connection type enter one or other of the Bold lines below):

Dial-up connections, add
RASWaitSeconds=120

Broadband connections, add
AlwaysConnectedWaitSeconds=120

The figure is seconds and the above equates to two minutes, you could try that and adjust upwards if required, 180, 240, etc.

Vlk · 2007-03-02T23:19:07.000Z

It’s worth noting that this will work only if the connection type is selected in avast program settings (dial-up or broadband)

Cheers
Vlk

DavidR · 2007-03-02T23:30:43.000Z

Thanks Vlk.

system · 2007-03-03T01:59:29.000Z

Thanks! I assume that when an avast program update pulls down, it won’t over write my changes to this .ini?

Lisandro · 2007-03-03T11:31:27.000Z

MrRAlan post:5:

I assume that when an avast program update pulls down, it won’t over write my changes to this .ini?

Your assumption is right 8)

system · 2007-03-03T17:18:19.000Z

Thanks. The delay is working but the slowdown is still present until I unload avast services. I will start a new topic.

DavidR · 2007-03-03T19:01:05.000Z

What is your standard shield sensitivity setting, Normal, High, Custom ?
What other security programs do you have running at boot, firewall, anti-spyware, etc. ?

system · 2007-03-03T20:39:06.000Z

The sensitivity is set to normal and I only have Kerio Firewall and avast running at startup. I created a new topic for this here…

http://forum.avast.com/index.php?topic=26984.0

Announcements