In the past i used Avast fast virus scan and Malwarebytes the same time.
I did this for years without any issue.
This curent version of Avast though stops Malwarebytes to load and start scan!
I had to diable Avast for 10 minutes and start Malwarebytes!
That’s it…Avast team it was a nice 7 years company but its time for me to change antivarius programme since you are making avast heavier and more problematic every update! >:(
I haven’t allowed MBAM 2.0 to run for a long time it became a resource hog. I had a lifetime license for three installations, but apparently that doesn’t grandfather into 3.0. So there was no way I was going to buy another lifetime license (life seems too short in MBAM )
I’m at the point of seriously considering uninstalling it completely, but for now it is on-demand only, I haven’t excluded anything for MBAM/Avast and no conflicts.
Well I got my information directly from MBAM support and the email reply was pretty clear it wasn’t and I should continue using MBAM 2.0 or the free version of MBAM 3.0. I also couldn’t find anything clear on their site to say I could use my license with MBAM 3.0 hence my question to MBAM.
So that doesn’t go down well with me, when I asked a fairly clear question about using my license with MBAM 3.0.
Now it is very much water under the bridge it has been removed on all of my systems.
I’ve always had problems with Malwarebytes 2.0 on XP. It didn’t matter whether I had Avast or Panda as my antivirus. I have no problems with the old Malwarebytes 1.75. That doesn’t clash with anything. I’d go with the current Avast, MCShield, CryptoPrevent, and the old 1.75 Malarebytes…but, as ever, it’s up to individuals to make their own choices.