system
4
OK… i did another clean install from Win7 (reverted to a clean installed snapshot) now the deployment runs good…
cant figure out why since for the rest there hasnt been anything changed in settings on either side…
however in the remote install log from SBC the deployment (I monitor it by reopening the logfile every so many seconds) it shows that the setup was running at 70% for 5minutes and 50 seconds (noticed this in previous beta too)…
i looked in the client settings and found an option where you can set the ip or dnsname for the console.
THis is filled in already AND filled with the correct information, it shows the DNS name from my SBC server…
I changed the DNS to the IP, without luck… the server can be accessed without problems…
I checked with wireshark if there is any communication…
there seems to be a lot of communications between the server and the client, but only in the form of ack/sync pakkets…
cant find any data packets
would it help if i dump a communication file for the more experienced network pakket inspection people?